Debug Ip Rip - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

debug ip rip

debug ip rip ripLog [ severity { severityValue | severityNumber } ]
Syntax
[ verbosity verbosityLevel ]
no debug ip rip ripLog
Command introduced before JUNOSe Release 7.1.0.
Release Information
Shows information about the selected variable. The no version disables the display.
Description
Options
Privileged Exec
Mode
490
debug ip rip
ripLog—RIP log of interest; one of the following options:
events General RIP events, such as removing RIP from an interface or
creating the RIP process
route Events associated with two RIP routers exchanging routes
severity Specifies the minimum severity of the log messages displayed for the
selected category; described either by a descriptive term severityValue or by
a corresponding number severityNumber in the range 0–7; the lower the
number, the higher the priority:
emergency or 0 System unusable
alert or 1 Immediate action needed
critical or 2 Critical condition exists
error or 3 Error condition
warning or 4 Warning condition
notice or 5 Normal but significant condition
info or 6 Informational message
debug or 7 Debug message
verbosityLevel Verbosity of the log category's messages; can be any of the
following:
low Terse
medium Moderate detail
high Verbose