Ethernet Oam Lfm - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

ethernet oam lfm

[ no ] ethernet oam lfm
Syntax
Command introduced in JUNOSe Release 11.1.0.
Release Information
Enables 802.3ah Ethernet Operation, Administration, and Maintenance (OAM)
Description
link-fault management on an interface. Enabling IEEE 802.3ah OAM functionality
on a physical interface automatically triggers the discovery process. The default
discovery mode of the OAM entity is active. The no version disables OAM link-fault
management on the interface.
NOTE: If you enable OAM on an interface without specifying other parameters for
the local OAM entity, such as the discovery mode for the OAM entity and the interval
at which OAM protocol data units (PDUs) are sent to the remote peer, default values
are assigned to all the attributes that are not manually configured.
Interface Configuration
Mode
Related Topics
ethernet oam lfm mode on page 589
Guidelines for Configuring 802.3ah OAM Link-Fault Management
Configuring 802.3ah OAM Link-Fault Management
Chapter 6: E Commands
581
ethernet oam lfm