Ip Rpf-Route - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

ip rpf-route

ip rpf-route ipAddress addressMask
Syntax
{ nextHopIpAddress | nextHopInterfaceType nextHopInterfaceSpecifier }
[ distanceValue ] [ tag tagValue ]
[ no ] ip rpf-route ipAddress addressMask
Command introduced before JUNOSe Release 7.1.0.
Release Information
Customizes static routes that the router can use to verify source addresses in multicast
Description
packets. The no version removes the static route.
Options
Global Configuration
Mode
ipAddress IP address of the destination network
addressMask Subnet mask for the destination network
nextHopIpAddress IP address of the next hop
nextHopInterfaceType—Interface type; see Interface Types and Specifiers on
page 5
nextHopInterfaceSpecifier—Particular interface; format varies according to
interface type; see Interface Types and Specifiers on page 5
distanceValue Number in the range 0–255 that indicates the preference for this
route
tagValue Number in the range 0–4294967295 that identifies the route in the
routing table
Chapter 10: I Commands
937
ip rpf-route