Data-Character-Bits - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

data-character-bits

data-character bits { 7 | 8 }
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
Sets the number of data bits available for characters for all sessions on the specified
Description
vty lines. There is no no version.
Options
Line Configuration
Mode
476
data-character-bits
7 Specifies 7 data bits per character; this setting supports only characters in
the standard ASCII set
8 Specifies 8 data bits per character; default setting, supports the full set of
8-bit international characters