Mpls Ldp Vpls Vpls-Id - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

mpls ldp vpls vpls-id

mpls ldp vpls vplsName vpls-id vplsId
Syntax
no mpls ldp vpls vplsName vpls-id
Command introduced in JUNOSe Release 8.2.0.
Release Information
Configures the globally unique VPLS identifier of a VPLS instance that uses LDP as
Description
the signaling protocol. All VEs that participate in the same VPLS domain must use
the same VPLS identifier. The VPLS identifier configured for a VPLS instance must
not be the same as the PWid for Martini configurations for Ethernet layer 2 services
over MPLS. The no version deletes the VPLS identifier from the VPLS instance.
The mpls ldp vpls vpls-id command is not valid for a VPLS instance that uses BGP
as the signaling protocol. To configure a VPLS instance with BGP signaling, use the
bridge vpls rd, bridge vpls route-target, bridge vpls site-name site-id, and bridge vpls
site-range commands.
Options
Global Configuration
Mode
Related Topics
1382
mpls ldp vpls vpls-id
vplsName Name of a VPLS instance created with the bridge vpls
transport-virtual-router command
vplsId VPLS identifier for the VPLS instance, in the range 1–4294967295
Configuring LDP Signaling for VPLS in the JUNOSe BGP and MPLS Configuration
Guide