Ip Rip Authentication Mode - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

ip rip authentication mode

ip rip authentication mode { text | md5 keyID }
Syntax
no ip rip authentication mode
Command introduced before JUNOSe Release 7.1.0.
Release Information
Specifies the type of authentication used on this interface. The no version removes
Description
authentication from the interface. Supported only in RIP version 2. Authentication
is disabled by default.
Options
Interface Configuration, Subinterface Configuration
Mode
924
ip rip authentication mode
text Sends a simple text password with each RIP message; if the password is
not possessed by neighbors, the message is rejected
md5 Encrypts and compresses the RIP message with MD5 message-digest
algorithms
keyID Number identifying the MD5 key; neighbors must share the MD5 key to
decrypt the message and encrypt the response