Mpls Ldp Session Holdtime - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

Chapter 13: M Commands

mpls ldp session holdtime

mpls ldp session holdtime holdTime
Syntax
no mpls ldp session holdtime
Command introduced before JUNOSe Release 7.1.0.
Release Information
Configures the LDP session hold time, the period that an LSR maintains a session
Description
without receipt of a message from an LDP peer. Each LSR peer sends the session
hold time in its initialization message; peers negotiate to use the minimum of the
session hold times proposed by the pair of LSRs. This negotiated session hold time
is used by the keepalive timer to maintain the session.
The keepalive timer is reset with the receipt of any session message from the peer.
In the absence of other LDP protocol messages are being sent, peers periodically
send a keepalive message to maintain the LDP session.
The LDP session is terminated when the timer expires. The no version restores the
default value, 180.
holdTime Number of seconds in the range 15–65535
Options
Global Configuration
Mode
1371
mpls ldp session holdtime