Ip Vrrp Icr-Partition Svlan-Range - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

ip vrrp icr-partition svlan-range

ip vrrp vrid icr-partition svlan-range [ svlanIdStart svlanIdEnd ]
Syntax
[ use-default-mac ] [ control-interface ] [ advertise-mac ]
no ip vrrp vrid icr-partition svlan-range [ svlanIdStart svlanIdEnd ]
Command introduced in JUNOSe Release 10.3.0.
Release Information
Adds a range of S-VLANs to the ICR partition. You can only assign unique S-VLANs
Description
to the partition. If you attempt to assign a previously assigned S-VLAN range to the
ICR partition, the router displays an error message. You can assign S-VLANs only if
you have selected S-VLAN based grouping by using the ip vrrp icr-partition group
command. The no version deletes the S-VLAN range from the ICR partition.
NOTE: You can use the listed optional parameters only when you add a S-VLAN or
a range of S-VLANs to the ICR partition. You cannot modify an existing subinterface
using these parameters. You can specify the optional parameters in any order.
Options
Interface Configuration, Subinterface Configuration
Mode
Related Topics
982
ip vrrp icr-partition svlan-range
vrid VRID identifier; a number in the range 1–255
svlanIdStart Starting S-VLAN ID of the S-VLAN subrange you are configuring; a
number in the range 0–4095
svlanIdEnd Ending S-VLAN ID of the S-VLAN subrange you are configuring; a
number in the range 0–4095
use-default-mac Configures the S-VLAN range to use the default MAC address.
By default, the router assigns the VRRP MAC address to all subinterfaces of the
ICR partition.
control-interface Controls traffic on a range of subinterfaces that are part of
a backup partition. When you use this option, the router changes the state of
the corresponding range of subinterfaces to Admindown. When the subinterfaces
are in Admindown state, the router blocks all traffic to the interfaces. However,
the router does not block advertisements as long as VRRP is running on a separate
subinterface. The router changes the state of the range of subinterfaces from
Admindown to Up when the state of the partition changes from backup to master.
advertise-mac Enables subinterfaces to transmit GARP advertisements when
the partition moves from backup state to master state. By default, GARP
advertisements are blocked on subinterfaces.
Grouping ICR Subscribers Based on S-VLAN IDs
Configuring an ICR Partition