L2Tp Destination Lockout-Timeout - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

l2tp destination lockout-timeout

l2tp destination lockout-timeout timeOutValue
Syntax
no l2tp destination lockout-timeout
Command introduced in JUNOSe Release 7.2.0.
Release Information
Specifies the amount of time an L2TP destination remains in the lockout state after
Description
the destination becomes unavailable. When the timeout period expires, the router
either begins the lockout test procedure (if configured to do so) or immediately returns
the destination to service. The no version restores the default lockout timeout value.
Options
Global Configuration
Mode
timeOutValue Number of seconds in the range 60–3600; default is 300 seconds
(5 minutes)
Chapter 12: L Commands
l2tp destination lockout-timeout
1161