Mpls Ldp Profile - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

mpls ldp profile

In Global Configuration mode:
Syntax
mpls ldp [ interface ] profile [ profileName ]
no mpls ldp interface profile profileName
In Interface Configuration mode:
mpls ldp profile profileName
no mpls ldp profile
Command introduced before JUNOSe Release 7.1.0.
Release Information
In Global Configuration mode, creates or modifies a configuration profile for LDP.
Description
Places the CLI in LDP Configuration mode. The implicit default LDP profile specifies
a value of 0 for hello hold-time; this value signifies 15 seconds for link hellos and 45
seconds for targeted hello messages.
Any change to a profile affects all interfaces that use the profile; changes are effective
the next time the interface comes up.
In Interface Configuration mode, creates or enables LDP on the interface with the
factory default profile or the specified profile. The no version reverts to the default
profile on the interface.
In both modes, if you specify a profile not previously configured, it is created with
the factory default settings. If you do not specify a profile name, the factory default
profile is assumed. The no version deletes the specified profile.
Options
Global Configuration, Interface Configuration
Mode
interface Keyword required for the no version in Global Configuration mode
profileName Name of a profile to be created or modified (Global Configuration
mode), applied to an interface (Interface Configuration mode), or deleted (both
modes); the profile sets the values for the protocol parameters; until you modify
the profile settings, the values match those of the implicit default profile
Chapter 13: M Commands
1369
mpls ldp profile