Interface Atm - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

interface atm

[ no ] interface atm interfaceSpecifier [ multipoint | point-to-point ]
Syntax
Command introduced before JUNOSe Release 7.1.0.
Release Information
Configures an ATM interface or subinterface type. The no version removes the
Description
interface or subinterface.
NOTE: On the OC3-2 GE APS I/O module, you can configure only OC3/STM1 ATM
interfaces in ports 0 and 1. Port 2 is reserved for a Gigabit Ethernet interface.
Options
Global Configuration, Interface Configuration
Mode
Related Topics
interfaceSpecifier—Particular interface; format varies according to interface type;
see Interface Types and Specifiers on page 5
multipoint Specifies an NBMA subinterface
point-to-point Specifies an ATM interface or subinterface; default
Configuring an MPLS Pseudowire with VCC Cell Relay Encapsulation, Configuring
Local ATM Cross-Connects with AAL5 Encapsulation, and Configuring MPLS LSPs
for L2VPNs in the JUNOSe BGP and MPLS Configuration Guide
Chapter 10: I Commands
719
interface atm