Ipv6 Ospf Transmit-Delay - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

ipv6 ospf transmit-delay

ipv6 ospf [ processId ] transmit-delay transmDelay
Syntax
no ipv6 ospf [ processId ] transmit-delay
Command introduced before JUNOSe Release 7.1.0.
Release Information
Sets the estimated time it takes to transmit a link-state update packet on the interface.
Description
The no version restores the default value.
Options
Interface Configuration, Subinterface Configuration
Mode
processId Integer in the range 1–65535
transmDelay Link-state transmit delay, a number in the range 0–3600 seconds;
default value is 1 second
Chapter 10: I Commands
ipv6 ospf transmit-delay
1089