Controlled-Interface-Type - Juniper JUNOSE 11.1.X - COMMAND REFERENCE A TO M 4-9-2010 Command Reference Manual

JUNOSe 11.1.x Command Reference Guide A to M

controlled-interface-type

controlled-interface-type { controlledInterfaceType | set | superset }
Syntax
no controlled-interface-type { controlledInterfaceType | all }
Command introduced in JUNOSe Release 7.1.0.
Release Information
set and superset keywords added in JUNOSe Release 9.2.0.
Assigns controlled-interface types to a QoS parameter definition. Controlled-interface
Description
types specify the types of logical interfaces whose queues and nodes can be controlled
by instances of the parameter definition. You can specify up to four
controlled-interface types for each parameter definition. The no version removes
the controlled-interface type from the parameter definition.
Options
QoS Parameter Definition
Mode
Related Topics
460
controlled-interface-type
controlledInterfaceType One of the following controlled-interface types: atm,
atm-vc, atm-vp, bridge, ethernet, fr-vc, ip, ip-tunnel, ipv6, l2tp-session, l2tp-tunnel,
lsp, serial, svlan, server-port, vlan
set Specifies an interface set as a controlled-interface type
superset Specifies an interface superset as a controlled-interface type
all Removes all controlled-interface types
Configuring a Basic Parameter Definition for QoS Administrators
Creating a QoS Parameter on an Interface Superset or Interface Set