Settings
Tones
Switching the Busy Tone for the End of Call On/Off
Note: If the special tone is configured as the internal dial tone, it is no longer
possible to differentiate it from the special dial tone.
Further steps:
– Save your settings before you leave the page.
Switching the Busy Tone for the End of Call On/Off
If busy tone for end of call is enabled, the PBX generates a busy tone at the end of the call
(e.g., the communication partner hangs up).
For some answering machines, this busy tone does not interrupt a recording. These answering
machines cannot differentiate between the busy tone and speech. For such cases, the busy
tone can be disabled.
Switching this on/off can be done as follows:
• Separately for subscribers
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorisation
– Expert view (click
1. Open the page PROPERTIES > Internal subscribers > Subscriber properties >
Signalization by tones.
2. In the list field at the top, select the subscriber in question by his name or number.
3. Select or clear the Busy tone at end of call check box.
Enables the busy tone at the end of a call.
Disables the busy tone at the end of a call.
Further steps:
– Save your settings before you leave the page.
484
)
COMpact 3000 analog/ISDN/VoIP - Firmware V4.0 - Operating Manual V06 12/2020