Telephone Number Display (Clip); Switching Clip Information On/Off - Auerswald COMpact 3000 analog Installation, Operation And Configuration Instructions

Configuring and Operating Functions

Telephone Number Display (CLIP)

Switching CLIP Information On/Off

Telephone Number Display (CLIP)
The telephone number display (CLIP) enables the telephone number of the caller to be shown
on the display of a system telephone, an ISDN telephone or on a CLIP-capable analog
telephone. The prerequisite is that the caller transmits a telephone number.
A few CLIP-capable analog telephones support the recording of the date and time in
conjunction with the caller list. On some, it is also possible to display the name instead of the
telephone number.
Switching CLIP Information On/Off
If CLIP information is enabled, the telephone number information (if transmitted) is displayed
on the display of CLIP-capable analog telephones.
Note: A caller's telephone number (if transmitted) is automatically displayed
on ISDN telephones.
Switching this on/off can be done as follows:
• Separately for subscribers
• Via the configuration manager
Requirements:
– Configuration manager, opened with sufficient authorization
– Expert view (click
– Analog subscriber
1. Open the page PROPERTIES > Internal subscribers > Subscriber properties >
Analog settings.
2. In the list field at the top, select the subscriber in question by his name or number.
3. Select or clear the CLIP info check box under Telephone number display (CLIP).
Enables CLIP information.
Disables CLIP information.
Further steps:
– Save your settings before you leave the page.
COMpact 3000 analog/ISDN/VoIP - Firmware Version 4.0 - Version of the Manual 03 02/11
)
305