Table of Contents
Advertisement
Commissioning
This chapter may help you to put the PBX into operation for the first time
and to make the necessary basic configuration to enable internal as well
as external telephony.
Connect the PBX with the NT. The different possibilities are described
starting on
page
22.
Connect the COMmander Basic with an unobstructed and accessible
230 Volt wall socket with protection earth contact.
After power-on, the case LED will glow red (orange) for some seconds:
The COMmander Basic is initializing.
As soon as the colour of the LED changes into green, the
COMmander Basic is ready for operation. But if the LED remains to be
red, there may be some defect.
If you like to do a functional test prior to the configuration of
the PBX, e.g. you will be able to make an internal call. Simply
use the internal telephone numbering plan that was created
by the PBX during the first operation. The initially created internal tele-
Now start the connected PC and install the configuration programs
COMset from the Auerswald Mega Disk.
Insert the CD-ROM (Auerswald Mega Disk) into the CD-ROM drive.
Windows 95/98/Me usually has an Autostart functionality for the
Setup. Sometimes the installation will not be started automatically.
In this case you can start Setup manually: On your desktop click on
the „Start" button in the task bar and select „Run".
Click on „Browse".
Open the CD-ROM drive with the Auerswald CD-ROM. Select the
application „Setup" in the root directory by double click.
Then click on „OK".
Follow the instructions on the screen. You will find the installation
for the configuration programs COMset under the software for the
COMmander Basic.
Precondition is that you have already done the installation described in
the preceding chapters or at least that you have connected the PC for
the configuration as well as some telephones for a first test.
First Operation
phone numbering plan is described in
tings on page
tem telephones, ISDN telephones as well as ISDN PC-controllers must
match with the here created internal number (please consult the
Configuration of ISDN Devices on page 39
MSN of the corresponding device is also presented to the PBX).
For some ISDN devices as well as for the system telephones COMfort
1200 and COMfort 2000 the connection to the 230 V mains has to be
made before.
If the NT is equipped with a 230 V power cable and if additional passive
devices are connected to the NT in parallel to the PBX, the NT has to
be connected to a 230 V mains outlet. If the PBX is exclusively con-
nected to the NT, the NT can be used without an additional power sup-
ply to save energy.
Install Configuration Software
Commissioning
chapter The Default Factory Set-
42). The 1st MSN entered into individual Auerswald sys-
and make sure that this 1st
35
chapter
Advertisement
Table of Contents
