Selecting The Language; Configuring The Port On The Web Server - Auerswald COMpact 5000 Operation Manual

Pbx for analogue/isdn/internet telephony

Hide thumbs Also See for COMpact 5000:

Table of Contents

Any changes made on the current page will not be saved if you leave the

configuration wizard using the symbol

Changes to the network configuration (IP address static or via DHCP client)

were only saved at first, but not enabled. They will only be enabled when you

leave the configuration wizard using step 11, End, or the symbol

dialogue appears which allows you to decide whether the changes are to be

enabled immediately or after a restart of the PBX.

If you want to change or expand your settings after leaving the configuration wizard, open the

configuration wizard again or go to the page referenced in each individual step.

Selecting the Language

You can select the language for the configuration manager.

Proceed as follows:

• Using the configuration manager

1. Open the page Administration > IP configuration.

2. Select the desired language in the Language list field under Server configuration.

Port 80 is used for accessing the web server by default. The address can thus be entered as

follows: http://192.168.55.13, for example. Only when accessing via Ethernet the value (e. g.

8081 instead of 80) has to be entered when modifying the port (e. g. http://

192.168.55.13:8081). A change of the port should be made for security reasons especially if

the PBX has to be accessible from the Internet (via a router and a fixed IP address).

You can view the ports already configured on the Overview > Ports page.

COMpact 5000/R - Firmware V6.6A - Installation, Operation and Configuration V05 03/2016

Introduction to the Configuration Manager

Configuration Manager

Selecting the Language

Compact 5000r