Ip Rip Authentication Mode - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual

JunosE 11.2.x Command Reference Guide A to M

ip rip authentication mode

Syntax
Release Information
Description
Options
Mode
918
ip rip authentication mode { text | md5 keyID }
no ip rip authentication mode
Command introduced before JunosE Release 7.1.0.
Specifies the type of authentication used on this interface. The no version removes
authentication from the interface. Supported only in RIP version 2. Authentication is
disabled by default.
text—Sends a simple text password with each RIP message; if the password is not
possessed by neighbors, the message is rejected
md5—Encrypts and compresses the RIP message with MD5 message-digest algorithms
keyID—Number identifying the MD5 key; neighbors must share the MD5 key to decrypt
the message and encrypt the response
Interface Configuration, Subinterface Configuration
Copyright © 2010, Juniper Networks, Inc.