Ip Pim Data Mdt Configuration Mode; Ip Service Profile Configuration Mode; Ipsec Ca Identity Configuration Mode - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04 Configuration Manual
Software for e series broadband services routers system basics configuration guide
Hide thumbs
Also See for JUNOSE SOFTWARE FOR E SERIES 11.3.X - SYSTEM BASICS CONFIGURATION GUIDE 2010-10-04:
- Configuration manual (304 pages) ,
- Reference manual (284 pages)
Table of Contents
Advertisement
JunosE 11.3.x System Basics Configuration Guide
IP PIM Data MDT Configuration Mode
IP Service Profile Configuration Mode
IPSec CA Identity Configuration Mode
90
log
Configure logging settings
macro
Run a CLI macro
no
Negate a command or set its default(s)
run
Run an exec mode command (alias command do)
sleep
Make the Command Interface pause for a specified duration
In this mode, you can specify parameters for data MDTs.
From Global Configuration mode, type ip pim data-mdt, and press Enter:
host1:pe1:pe13(config)#ip pim data-mdt
host1:western:eastern(config-ip-pim-data-mdt)#?
default
Set a command to its default(s)
do
Run an exec mode command (alias command run)
exit
Exit from the current command mode
help
Describe the interactive help system
log
Configure logging settings
macro
Run a CLI macro
mdt-data-delay
Configure MDT_DATA_DELAY timeout
mdt-data-holdown
Configure MDT_DATA_HOLDOWN timeout
mdt-data-timeout
Configure MDT_DATA_TIMEOUT
mdt-interval
Configure MDT_INTERVAL timer
no
Negate a command or set its default(s)
route-map
Configure route-map
run
Run an exec mode command (alias command do)
sleep
Make the Command Interface pause for a specified duration
tunnel
Configure tunnel parameters
In this mode, you can specify the information that the system uses in creating IP service
profiles.
From Global Configuration mode, type ip service-profile and the service profile name,
and press Enter.
host1(config)#ip service-profile radius
host1(config-service-profile)#?
default
Set a command to its default(s)
do
Run an exec mode command (alias command run)
domain
Configure a username domain
exit
Exit from the current command mode
help
Describe the interactive help system
include
Configure an attribute to be included in a username
log
Configure logging settings
macro
Run a CLI macro
no
Negate a command or set its default(s)
password
Configure a user password
run
Run an exec mode command (alias command do)
sleep
Make the Command Interface pause for a specified duration
user-name
Configure a user name
user-prefix
Configure a username prefix
In this mode, you can specify the information that the system uses in online certificate
requests and during negotiations with its peers.
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Troubleshooting
