Ip Pim Spt-Threshold - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
JunosE 11.2.x Command Reference Guide A to M
ip pim spt-threshold
Syntax
Release Information
Description
Options
Mode
902
[ no ] ip pim spt-threshold { 0 | nonzero_integer | infinity } [ group-list ipAccessList ]
Command introduced before JunosE Release 7.1.0.
Specifies the network configuration that PIM sparse mode uses when a source starts
sending multicast messages. The no version restores the default value, 0.
0—Configures PIM sparse mode to switch to an SPT when a source begins to send
multicast messages
nonzero_integer—Integer in the range 1–4294967294; prevents PIM sparse mode from
switching from a shared tree to an SPT
infinity—Prevents PIM sparse mode from switching from a shared tree to an SPT
ipAccessList—Name of the IP access list that specifies the groups to which the threshold
applies
Global Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
Need help?
Do you have a question about the JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 and is the answer not in the manual?
Questions and answers