Bvi Interface Command Set - ADTRAN AOS Version R10.1.0 Command Reference Manual

Command Reference Guide
BVI I
NTERFACE
To activate the Bridged Virtual Interface Configuration mode, first enable integrated routing and bridging
(IRB) via the bridge irb command (refer to
prompt. For example:
>enable
#configure terminal
(config)#bridge irb
Next, enter the interface bvi command and a specific interface number that corresponds to an existing
bridge group at the Global Configuration mode prompt. For example:
(config)#bridge irb
(config)#interface bvi 1
(config-bvi 1)#
The following commands are common to multiple command sets and are covered in a centralized section
of this guide. For more information, refer to the sections listed below:
cross-connect on page 67
description <text> on page 70
do on page 71
end on page 72
exit on page 73
interface on page 74
shutdown on page 82
All other commands for this command set are described in this section in alphabetical order.
bandwidth <value> on page 2043
crypto map <name> on page 2044
dynamic-dns on page 2046
ip commands begin on page 2048
ipv6 dhcp relay destination <ipv6 address> on page 2077
ipv6 policy-class <ipv6 acp name> max-sessions <number> on page 2078
mac-address <mac address> on page 2079
max-reserved-bandwidth <value> on page 2080
packet-capture <name> on page 2081
qos-policy out <name> on page 2082
rtp quality-monitoring on page 2083
traffic-shape rate <value> on page 2084
vrf forwarding <name> on page 2085
60000CRG0-35E
C S
OMMAND ET
bridge irb on page
Copyright © 2012 ADTRAN, Inc.

BVI Interface Command Set

904) at the Global Configuration mode
2042