Ip Rpf-Route - Juniper JUNOSE SOFTWARE FOR E SERIES 11.3.X - COMMAND REFERENCE A TO M 2010-10-19 Command Reference Manual

ip rpf-route

Syntax
Release Information
Description
Options
Mode
Copyright © 2010, Juniper Networks, Inc.
ip rpf-route ipAddress addressMask
{ nextHopIpAddress | nextHopInterfaceType nextHopInterfaceSpecifier }
[ distanceValue ] [ tag tagValue ]
[ no ] ip rpf-route ipAddress addressMask
Command introduced before JunosE Release 7.1.0.
Customizes static routes that the router can use to verify source addresses in multicast
packets. The no version removes the static route.
ipAddress—IP address of the destination network
addressMask—Subnet mask for the destination network
nextHopIpAddress—IP address of the next hop
nextHopInterfaceType—Interface type; see Interface Types and Specifiers on page 5
nextHopInterfaceSpecifier—Particular interface; format varies according to interface
type; see Interface Types and Specifiers on page 5
distanceValue—Number in the range 0–255 that indicates the preference for this route
tagValue—Number in the range 0–4294967295 that identifies the route in the routing
table
Global Configuration
Chapter 10: I Commands
931