Assembly And Activation; Connecting The Computer; Computer Activation; Start, Control And Signals - Energetics E-204 Instruction Manual

Exercise monitor

Hide thumbs Also See for E-204:

Table of Contents

Assembly and activation

Data cable: Connect the data cable coming from the equipment with the

one coming from the computer [1] .

Mounting: Attach the computer to the mount on the equipment . Carefully

slide the insert sleeve on the back of the computer over the mount on the

centre post [2] .

Pay attention not do damage the data cable when sliding the computer

housing over the mount .

Then you fasten the four fixing bolts [3] .

Hand pulse sensors: Plug the hand pulse cable into the connector on the

back of the computer [4] .

Power supply: The computer gets its power supplied through the data cable

of your equipment. Note: the equipment has to be plugged in and turned

The computer can be activated by pressing any key or when the user starts

P R O G R A M

The computer starts with a short beep tone and the standard settings . The

program 1 (Manual Program) is displayed .

The user can start to input his settings .

Should the E-204 not receive a signal for more than 4 minutes it changes into

the sleep mode . The display turns dark . To start again press any key or start

If the computer does not receive a signal

for more then 4 minutes the sleep mode is

Table of Contents