FujiFilm CR-IR341 Service Manual page 487

Appendix 1. Supplementary Information
Appendix 1.1 Setting of Error Code to be Captured for IO Trace
If there is any error code is be captured for IO trace, it may be set as an error code to be
captured for IO trace
SUPPLEMENTARY NOTE
When an error code to be captured for IO trace (1XXX/2XXX) is set, the IO trace data for the error
code so set is saved in a separate memory when the error occurs.
The IO trace data saved may be written to a floppy disk by selecting "1. ERROR LOG UTILITY" and
"3. SAVE TO FD" of M-Utility in sequence.
How to set an error code to be captured for IO trace is described below.
(1) Start the M-Utility.
(2) Insert a floppy disk into the floppy disk drive (FDD) of the machine.
(3) Select "7. FILE UTILITY", "3. BACKUP", and "2. CONFIGURATION DATA" in
sequence.
The following files are copied to the floppy disk.
• IRSET.ORG
• FILMFMT.ORG
• IRSTATUS.ORG
(4) Remove the floppy disk from the FDD of the machine and insert it into the FDD of the
personal computer (PC).
When installing the configuration data that is edited on the PC to the machine, make
sure that software versions of the source and destination are the same.
If the software versions are different, an error may occur during installation.
(5) Using the editor on the PC, edit the IRSTATUS.CFG file.
Example)
To set the error code "1234" as the error code to be captured for IO trace, type in as
follows:
IOT_ERROR_CODE="1234"
(6) Remove the floppy disk containing the edited file from the PC, and insert it into the
FDD of the machine.
(7) Select "7. FILE UTILITY", "4. RESTORE", and "2. CONFIGURATION DATA" in
sequence.
The following files are copied to the HDD of the machine.
• IRSET.CFG
• IRSTATUS.CFG
(8) Remove the floppy disk from the machine.
(9) Press the RESET button to reboot the machine.
009-051-06
04.20.2001 FM3006
• IRSET.OFG
• FILMFMT.OFG
• IRSTATUS.CFG
• FILMFMT.CFG
CR-IR341 Service Manual
MT_A1 - 1
MT_A1 - 1