FujiFilm CR-IR341 Service Manual page 586

C 1 2
ONTENTS
6.6 Replacing and Adjusting Before-Side-Positioning
Conveyor Drive Timing Belt
There are two before-side-positioning conveyor drive timing belts. One is driven by the IP
transport motor (MC1) of the before-side-positioning conveyor, while the other is driven by
the IP transport motor (MF1) of the erasure conveyor.
Replacement of MC1-related Timing Belt
(1) Loosen the screw that retains the tensioner.
(2) Remove the timing belt.
(3) Attach a new timing belt.
(4) Adjust the MC1-related timing belt.
" Adjustment of MC1-related Timing Belt"
Adjustment of MC1-related Timing Belt
(1) Loosen the screw that retains the tensioner.
(2) While checking the belt tension with a push-pull gauge, adjust the position of the
tensioner.
Adjust the position of the tensioner until a proper tension is attained, and then tighten
the screw to secure the tensioner in place. The tension is as follows.
500g, 6 ± 1mm
009-051-04
05.31.99 FM2460
3 4 5 6
(2)
Timing belt
Before-side-positioning conveyor
(2)
Timing belt
Before-side-
positioning conveyor
CR-IR341 Service Manual
7 8 9 10
FRONT
(1)
Tensioner
Loosen
screw
MC1
FR1H1253.EPS
500g
6–1mm
FRONT
(1)
Tensioner
Loosen
screw
MC1
FR1H1251.EPS
MC - 95
MC - 95