FujiFilm CR-IR341 Service Manual page 829

1 2
C
ONTENTS
"64. PN_CS" through "78. PN_DC" (software version A12 or later)
The following settings are made regarding the patient name information for the image
that is subject to DICOM output (Base on DICOM) to QA-WS or CR-IR348CL.
• Definition of components of the name (Family name, Given name, Middle name,
Prefix, Suffix).
• Delimiter between components
<DICOM output with FINP input intact>
• PN_CS=0
Name components and delimiters are not converted.
Settings for PN_FDS/PN_FDM/ . . . . /PN_DC are ignored.
<Separated by delimiter when DICOM output is generated>
• PN_CS=1
Name components and delimiters are converted.
Settings for PN_FDS/PN_FDM/ . . . . /PN_DC are effective. Cases where the setting
for each of the items is at its initial value are described below.
• PN_FDS=O
Space is handled as a delimiter.
• PN_FDM=O
Full-width space is handled as a delimiter for a patient name in Kanji.
• PN_FCS1=F
• PN_FCS2="FG"
• PN_FCS3="FGM"
• PN_FCS4="FGMP"
• PN_FCS5="FGMPS"
PN_FCS1 through PN_FCS5 set components of a name (single-byte). If PN_FCS1
through PN_FCS5 are set as described above, they are defined as follows.
PN_FCS1: If there is only one component, it is interpreted as Family name. Assume
PN_FCS2: If there are two components, they are interpreted as Family name and
PN_FCS3: Assume that the patient name is "Rev. John M Smith Ph. D.". Then, if
009-051-07
009-051-07
08.30.2001 FM3115 (1)
08.30.2001 FM3115
3 4 5 6
that the patient name is "Fuji Taro". Then, if only "Fuji" is entered, "Fuji" is
interpreted as Family name.
Given name. Assume that the patient name is "Fuji Taro". Then, if "Fuji
Taro" is entered, "Fuji" is interpreted as Family name and "Taro" as Given
name (when the delimiter is a half-width space).
"Smith John M" is entered, "Smith" is interpreted as Family name, "John"
as Given name, and "M" as Middle name (when the delimiter is a half-
width space).
CR-IR341 Service Manual
7 8 9 10
MU - 41.5
MU - 41.5