C
1
2
ONTENTS
10.8 8. DATA MANAGEMENT: Displaying Data Setup Values and
Writing to HD
The setup value in "6. FORMAT" or "7. SHADING/SENSITIVITY" is displayed or written to
the hard disk.
1. SAVE SHADING AND POLYGON DATA: To Copy Invalid Pixels and Other Data into
Secondary Memory
It is used when shading or polygon correction is performed in "7. SHADING/SENSITIVITY".
Execute "1. SAVE SHADING AND POLYGON DATA".
Once it is executed normally, the following message appears.
XXXXXXXXXX IS SAVED.
Meaning: The file XXXXXXXXXX is saved.
If it ends in error, the following message appears.
FILE I/O ERROR. (FILE=XXXXXXXXXX)
XXXXXXXXXX represents the file name.
2. SAVE SENSITIVITY DATA: To Write Sensitivity Data to Hard Disk
It is used when sensitivity correction is performed in "7. SHADING/SENSITIVITY".
Execute "2. SAVE SENSITIVITY DATA".
Once it is executed normally, the following message appears.
XXXXXXXXXX IS SAVED.
Meaning: The file XXXXXXXXXX is saved.
If it ends in error, the following message appears.
FILE I/O ERROR. (FILE=XXXXXXXXXX)
XXXXXXXXXX represents the file name.
3. SAVE FORMAT DATA: To Write Read Start Position or Read Width Setup Value to
Hard Disk
It is used when the read start position or read width is set in "6. FORMAT".
Execute "3. SAVE FORMAT DATA".
Once it is executed normally, the following message appears.
XXXXXXXXXX IS SAVED.
Meaning: The file XXXXXXXXXX is saved.
If it ends in error, the following message appears.
FILE I/O ERROR. (FILE=XXXXXXXXXX)
XXXXXXXXXX represents the file name.
009-051-05
11.20.99 FM2638
3
4
5
6
CR-IR341 Service Manual
7
8
9
10
MU - 84
MU - 84