FujiFilm CR-IR341 Service Manual page 269

1 2 3 4
C
ONTENTS
Code Name
0401
File format error
0402
File setup value error
0403
File read error
0410
DSP4 device initialization error
0411
DSP4 device open error
0412 DSP4 µ program boot error
0413 DSP4 µ program load error
0414
DSP4 checksum error
0415
DSP4 self-diagnostics error
0420
DSP4 memory write error
009-051-04
05.31.99 FM2460
5 6
Significance/Occurrence Condition
The file format is improper.
The data of the file is improper.
A file cannot be read.
An attempt to initialize the DSP4 device fails.
An attempt to open the DSP4 device fails.
When a µ program is booted in DSP4, an error occurs.
When a µ program is loaded in the external memory of
DSP4, an error occurs.
A checksum on the DSP4 µ program results in an error.
Self-diagnostics on the DSP4 peripheral circuitry results in
an error.
A write to the DSP4 memory results in an error.
CR-IR341 Service Manual
Detail: Denotes the detail information format.
Probable Cause/Remedy
• The file format in the HDD is improper.
• The file in the HDD is corrupted.
• The HDD itself is faulty.
• The data described in the file in the HDD has an
out-of-range value.
• The file in the HDD is corrupted.
• The HDD itself is faulty.
The HDD or MTH08A board is faulty.
The CPU90E board or MTH08A board is faulty.
The CPU90E board or MTH08A board is faulty.
Check if the IMG07B board or MTH08A board is faulty,
or if µ program (DSP4M1J.S24) is present in the
hard disk.
Check if the IMG07B board or MTH08A board is faulty,
or if µ program (DSP4M1J.S24) is present in the
hard disk.
The IMG07B board or MTH08A board is faulty.
The IMG07B board or MTH08A board is faulty.
The IMG07B board or MTH08A board is faulty.
MT - 10
Detail Refer to
E-1
E-1
E-1
E-2
E-2
E-2
E-2
E-2
E-2
E-2
TR1H1224.EPS
MT - 10