FujiFilm CR-IR341 Service Manual page 912

C 11 12
ONTENTS
12.5 5. EDR DATA: Saving EDR Calculation to FD
NOTE
The following menus should not be used.
• 3. PARAMETER ONLY (SAVE TO HD)
• 4. FULL (SAVE TO HD)
• 3. DELETE EDR BACKUP ON HD
1. PARAMETER ONLY (SAVE TO FD): To Save EDR Calculation to FD
(1) Select "1. PARAMETER ONLY".
A list of up to ten images stored in the HD is displayed according to the following
format.
XXX) YYYY.MM.DD:ZZZZ
.
.
.
XXX) YYYY.MM.DD:ZZZZ
0.END 1-10.SELECT 11.NEXT 12.BEFORE (DEFAULT=11) :
Meanings of the items are as follows.
• XXX :
• YYYY.MM.DD : Image exposure date
• ZZZZ :
It should be noted that the display format of the last line in the list varies depending on
whether the previous page and/or next page is available.
(2) Type in "1 through 10", "11", or "12" to select an image to be saved to a floppy disk
(i.e., an image for which EDR calculated value is to be saved).
When either "1" through "10" is typed in, the following message appears.
PLEASE SET A FD.
ARE YOU SURE TO SAVE EDR PARAMETER DATA FILES TO THE FD ?
1.YES 2.NO (DEFAULT=2) :
Meaning: Put a floppy disk into the floppy disk drive. Are you sure to save EDR
(3) Select "1".
Once the data is copied to the floppy disk, the following message appears.
XXXXXXXXXX IS COPIED.
Meaning: XXXXXXXXXX is copied.
If the coping ends in error, the following message is displayed.
FILE I/O ERROR. (FILE=XXXXXXXXXX)
XXXXXXXXXX denotes the file name.
009-051-07
08.30.2001 FM3115
13 14 15 16
Reference number (1 to 999)
Image number (A001 to A999)
calcu.lation to the floppy disk?
CR-IR341 Service Manual
17
MU - 121
MU - 121