FujiFilm CR-IR341 Service Manual page 4

Getting Started
Servicing Instruments and Tools That Require Inspection/Calibration
The machine should be installed and serviced by use of servicing instruments and tools that
have been inspected and calibrated as appropriate.
If the machine were serviced using servicing instruments and tools that have not been
inspected and calibrated, proper performance of the machine could not be guaranteed.
Servicing instruments and tools that require inspection/calibration are as listed below.
Inspection/calibration procedures should be performed in accordance with the inspection/
calibration manuals described in the ECN Information.
Instruments and tools that require inspection/calibration
Name
Dosimeter
Steel rule (150mm)
Steel rule (300mm)
Digital tester
Calipers
Push-pull gauge
: A block gauge for use in inspection requires calibration.
009-051-07
08.30.2001 FM3115
Calibration
Inspection
–
–
–
( )
–
CR-IR341 Service Manual
Inspection/calibration manual No.
ECN No. FCR-A014
0.3
TR1H0001.EPS
0.3