FujiFilm CR-IR341 Service Manual page 890

C 11 12
ONTENTS
11.5 5. UNIT: 1. IP FEED/LOAD UNIT: Operation Tests on IP
Removal Mechanism
1. ARM HOME POSITION: To Locate HP of IP Removal Arm Mechanism
Execute "1. ARM HOME POSITION".
The following message appears.
ARM H.P. SETTING IS IN PROGRESS.
RESULT - OK (or RESULT - ERROR)
Meaning: IP removal arm home positioning is now being performed.
2. FEED/LOAD: To Feed or Load IP Removal Mechanism
(1) Execute "2. FEED/LOAD".
The following message appears.
INPUT THE MODE.
1. NORMAL MODE
2. STEP MODE
1 - 2 :
Meaning: Select the operation mode.
1. NORMAL MODE (normal mode)
2. STEP MODE (step mode)
(2) Enter the operation mode (either "1" or "2") of the IP removal arm.
The following message appears.
SET THE CASSETTE TO SHELF1.
Meaning: Set a cassette into the topmost shelf.
(3) Set a cassette.
When "1. NORMAL MODE" is selected
Once a sequence of operations is started, the following message appears.
THE FEED/LOAD PROCESS IS IN PROGRESS.
Meaning: Feed/load operation is now being performed.
When "2. STEP MODE" is selected
Once the operation is started stepwise, the following message appears.
THE FEED/LOAD PROCESS IS IN PROGRESS.
ARE YOU SURE TO MOVE ON NEXT STEP?
Meaning: Are you sure to proceed to the next step?
Hit the ENT key to proceed to the next step (there are six steps).
(4) When the operation is completed, pull out the cassette.
The following message appears.
RESULT - OK
If it ends in error, "ERROR (XXXX)" appears. "XXXX" denotes an error code.
009-051-05
11.20.99 FM2638
13 14 15 16
CR-IR341 Service Manual
17
MU - 99
MU - 99