FujiFilm CR-IR341 Service Manual page 517

1 2
C
ONTENTS
4. Cassette Set Unit
This section describes procedures for removing and reinstalling the cassette set unit, and
procedures for checking and replacing parts of the cassette set unit to be replaced.
4.1 Pulling Out and Pushing In Tray of Cassette Set Unit
CAUTION
When removing and installing the units, use care not to damage the cables.
Pulling Out
(1) Remove the following covers.
Lower front cover, upper right-hand side cover, lower right-hand side cover, upper left-
hand side cover, upper front cover, stack table, multi-stage cassette loading cover
"3. Removing and Reinstalling Covers"
(2) Disconnect the connectors (CNA1-3 from the cassette set unit; CNB1, 3, 4 from the
up-down IP removal unit).
(3) Slide the tensioner until the timing belt is removed, and then secure the tensioner in
place.
Loosen the screw (BR M4x8) that retains the tensioner to slide the tensioner as
appropriate, and then secure the tensioner in place.
"3.4 Tensioner Not Requiring Tension Adjustment" in Machine Description
(4) Remove the timing belt.
(5) Remove the two screws that retain the tray of the cassette set unit.
(6) Pull out the tray, exercising care so that it is not caught by the connector cables and so
forth.
(5)
Tray of the cassette set unit
009-051-04
05.31.99 FM2460
3 4 5 6
(6)
BR M4x8, x2
CR-IR341 Service Manual
7 8 9 10
Up-down IP removal unit
(2)
CNB4
CNB1
Vertical conveyor
(3), (4)
Cassette set unit
(2)
CNA3
BR M4x8
CNA1
CNA2
MC - 26
CNB3
Timing belt
Tensioner
FR1H1760.EPS
MC - 26