FujiFilm CR-IR341 Service Manual page 802

C 1 2
ONTENTS
6.MECHANICAL UTILITY
0.QUIT
1.MOTOR : Sets the pulse motor drive parameters and conducts pulse motor drive/stop tests.
0.QUIT
1.NUMBER
2.PARAMETER
3.DRIVE
4.STOP
2.ACTUATOR : Conducts solenoid, valve, pump, erasure lamp, and FFM drive/stop tests.
0.QUIT
1.NUMBER
2.DRIVE
3.STOP
3.SENSOR : Monitors the sensor status. Two monitoring methods are available:
0.QUIT
1.NUMBER
2.MONITOR
3.MONITOR ALL
4.UNIT
0.QUIT
1.IP FEED/LOAD UNIT : Performs operation tests on the IP removal mechanism.
2.UP-DOWN UNIT : Performs operation tests on the elevation unit. Displays a
3.SIDE-POSITIONING GRIP : Performs operation tests on the side-positioning
4.SIDE-POSITIONING UNIT : Performs operation tests on the side-positioning
5.AFTER-READING GRIP : Performs operation tests on the after-reading
NOTE: Numerals in brackets denote a relevant chapter in this manual.
009-051-05 009-051-06
04.20.2001 FM3006
11.20.99 FM2638
3 4 5 6
: Monitors individual operation of the motor, sensor status, etc.
Used for checking the motors and sensors.
one is for monitoring the sensors on an individual basis, and the other is
for monitoring all sensors at a time.
Displays a message if any abnormality is encountered. ˚
0.QUIT
1.ARM HOME POSITION
2.FEED/LOAD
message if any abnormality is encountered. ˚
0.QUIT
1.HOME POSITION
2.SETTING UNIT POSITION
0.QUIT
1.HOME POSITION
2.GRIP
3.RELEASE
0.QUIT
1.HOME POSITION
2.ACTUATION
conveyance grip. Displays a message if any abnormality
is encountered.˚
0.QUIT
1.HOME POSITION
2.GRIP
3.RELEASE
CR-IR341 Service Manual
7 8 9 10
conveyance grip mechanism. Displays a message
if any abnormality is encountered. ˚
mechanism. Displays a message if any abnormality is
encountered.
MU - 19
[11.]
[11.2]
[11.3]
[11.4]
[11.5]
[11.6]
[11.7]
[11.8]
[11.9]
FR1H1388.EPS
MU - 19