FujiFilm CR-IR341 Service Manual page 373

1 2
C
ONTENTS
03C2 Reading IP Leading-Edge Detection Error
Cause
When IP reading conveyance is initiated, SZ1 cannot detect the IP leading edge.
Supplementary explanation
After the IP side-positioning operation is completed, the side-positioning stopper is
released, and the IP is conveyed toward the subscanning unit by the driving of MD3.
MZ3 of the subscanning unit is driven to perform the grip/grip release operation of the
driven shaft.
The IP is conveyed to the subscanning unit, and passes over SZ1. (SZ1: OFF to ON)
As the IP passes over SZ1 (SZ1: OFF to ON), the IP leading edge is detected.
This error occurs when the IP fails to pass over SZ1 (SZ1 status does not transition
from OFF to ON) during the above operation.
Sensor related
Error-related I/O locations
MZ1
Subscanning motor
Error-related system block diagram
AC IN
DC OUT6
JPS-1
DC OUT3
009-051-04
05.31.99 FM2460
3 4 5 6
ON: Close, OFF: Open
CN
CN4
CN9
SCN08A
DRV03D
CN14
DRV08A
CN1
CR-IR341 Service Manual
SOLA4
SZ1
IP leading edge sensor
FR1H0049.EPS
CNZ11
CN2
CNZ4
CN3
MZ1
CN1
FR1H0050.EPS
MT - 104
MT - 104