FujiFilm CR-IR341 Service Manual page 167

C 1 2
ONTENTS
3. Machine Operation During Secondary Erasure
3.1 Summary of Operation
This is for the sequence of "secondary erasure conveyance" in the Maintenance Utility.
It is different from the routine (single-IP conveyance) in the following five points.
1. Barcode reading :
2. Reading :
3. Erasure :
(1) Machine Operation during Secondary Erasure (Overall/General Flow)
Fig. 3.1.1 Machine Operation during Secondary Erasure
Same as in the routine
Cassette set unit
Same as in the routine
UP-down IP removal unit
Same as in the routine
Up-down IP removal unit
Same as in the routine
Before-side-positioning conveyor
Barcode reading is not performed.
The reset are the same as in the routine.
Side-positioning conveyor
The reading preparation and reading
conveyance are different than in the routine.
Reading conveyor
erasure conveyor
Same as in the routine
Up-down IP removal unit
The erasure conveyance speed is different
than in the routine.
The rest are the same as in the routine.
Erasure conveyor
Same as in the routine
Before-side-positioning conveyor
up-down IP removal unit
Same as in the routine
Cassette set unit
009-051-05
009-051-04
04.20.2001 FM3006 05.31.99 FM2460
3 4 5 6
The sequence is skipped.
The sequences for reading
preparation and reading are different.
The sequence of steps is the same,
but at different conveyance speeds.
after-reading conveyor
CR-IR341 Service Manual
7 8 9 10
START
Cassette IN
See 2.2
Movement of elevation unit
(feed)
See 2.3
IP feed
See 2.4
Passage through before-side-
positioning conveyor and IP length
measurement
See 2.5
Side-positioning (secondary erasure)
See 3.2
Reading (secondary erasure)
See 3.3
Erasure
See 3.4
IP load
See 2.10
Cassette ejection
See 2.11
END
MD - 104
See Section 3.2.
See Section 3.3.
See Section 3.4.
Movement of
elevation unit
(load)
See 2.8
FR1H0388.EPS
MD - 104