FujiFilm CR-IR341 Service Manual page 298

1 2 3 4
C
ONTENTS
Code Name
2574
Laser error 3
2575
Start-point detection error 3
2576
Leading-edge detection error 3
2713
Unexpected command received
2714
Serial line test error
2716
File write error
271C
SMCU driver hard error
2723
Unexpected command received
2725
Connection establishment error
2726
Connection establishment error
2727
Connection establishment error
2751
File open error
2752
File format error
2753
File write error
009-051-04 009-051-06
04.20.2001 FM3006
05.31.99 FM2460
5 6
Significance/Occurrence Condition
With status check during system shutdown after reading
error, an error is detected.
With status check during system shutdown after reading
error, an error is detected.
With status check during system shutdown after reading
error, an error is detected.
An illegal command is received with SMCU.
The serial line test result is improper.
An error occurs while opening, writing, or closing the SMCU
log file.
A hard error occurs with the SMCU driver.
An illegal command is received over the network.
An attempt to establish a connection to receive a command
fails.
An attempt to establish a connection with the IDT in IDT
Utility mode fails.
An attempt to establish a connection for command reception
fails.
An attempt to open a file fails.
File format check error
An attempt to write a file fails.
CR-IR341 Service Manual
Detail: Denotes the detail information format.
Probable Cause/Remedy
Faulty SCN board, scanner hardware, etc.
Faulty SCN board, scanner hardware, etc.
Faulty SCN board, scanner hardware, etc.
• A failure occurs on the IDT.
• The SMCU driver is faulty.
The SMCU driver is faulty.
HD is failure.
CPU board is failure.
• A failure occurs on the IDT.
• The network environment is faulty.
The network environment is faulty.
The network environment is faulty.
The network environment is faulty.
• No file
• HD failure
File description is improper.
HD failure
MT - 35
Detail Refer to
E-3
E-3
E-3
F
F
A-1
E
H
H
H
H
A-1
A-1
A-1
TR1H1249.EPS
MT - 35