FujiFilm CR-IR341 Service Manual page 607

C 1 2
ONTENTS
8.4 Checking and Replacing Side-Positioning IP Sensor (SD3)
Checks
CAUTION
Before removing the covers, be sure to turn OFF the high-voltage switch. If the machine is
powered ON with any of the covers removed, the photomultiplier will be damaged.
(1) Remove the side-positioning conveyor.
"8.1 Removing and Reinstalling Side-Positioning Conveyor"
(2) Remove the SD3 and spacer with the connector (CNSD3) attached.
(3) Connect CND1.
(4) Power ON the machine.
The initialization sequence starts, and after an elapse of about 30 to 60 seconds, the
software version number (Axx) appears on the operation panel.
(5) Immediately after the software version number (Axx) appears, touch the upper left and
upper right corners of the operation panel in sequence.
M-Utility is activated.
When "STEP 95" appears on screen, any subsequent touch on the operation panel is
rejected. In that case, reset the machine and wait until the software version number
(Axx) appears.
(6) Make the side-positioning IP sensor (SD3) to be in the sensor monitoring enabled
state.
"2.2 Checking Various Sensors"
(7) Using a piece of cardboard, block the SD3 light path.
A message indicating that the sensor is CLOSE is displayed on the operation panel.
(8) Remove the piece of cardboard that blocks the SD3 light path.
A message indicating that the sensor is OPEN is displayed on the operation panel.
(9) Repeat steps (7) and (8) several times.
If anything abnormal is found, such as no message displayed, then replace the sensor.
(2)
Spacer
(2)
SD3
Pan-head
M3x10, x2
009-051-04
05.31.99 FM2460
3 4 5 6
(3)
CND1
CNSD3
Side-positioning conveyor
CR-IR341 Service Manual
7 8 9 10
FR1H1778.EPS
MC - 116
MC - 116