FujiFilm CR-IR341 Service Manual page 302

1 2 3 4
C
ONTENTS
Code Name
2940
SMCU transmission error
2941
Receive line break detection
2942
Unexpected command received
2943
MCU receive error
2944
Image output terminated
2945
Output interrupted by abort instruction
2946
DSP application execution error
2947
Image data output error
2948
Image data output error
2949
Image data output error
294A
Image data output error
294B
Image data output error
009-051-04
05.31.99 FM2460
5 6
Significance/Occurrence Condition
A transmission of a command to the DMS fails during output.
A receive line break-ON is received during output.
An undefined command is received during output.
A reception of a command from the DMS fails during output.
An image input termination notification is received from the
DMS.
The output is interrupted by an abort instruction.
A timeout occurs during startup of a DSP application.
While waiting for an image transfer reservation response,
a timeout occurs.
While waiting for an image information transfer request,
a timeout occurs.
While waiting for an image data transfer standby response,
a timeout occurs.
While waiting for an image data transfer completion report,
a timeout occurs.
While waiting for an image output completion response,
a timeout occurs.
CR-IR341 Service Manual
Detail: Denotes the detail information format.
Probable Cause/Remedy
• Timeout
• Break state on the target end
• Break state on the source end
• The serial line is disconnected.
• A failure occurs on the DMS.
• A failure occurs on the DMS.
• The SMCU driver is faulty.
• Command wait timeout
• Break state on the target end
• Break state on the source end
The DMS issues an image input termination notification.
The power switch is OFF.
The DMC08A board is faulty.
The DMC08A board is faulty.
The DMC08A board is faulty.
The DMC08A board is faulty.
The DMC08A board is faulty.
The DMC08A board is faulty.
MT - 39
Detail Refer to
E
F
G
E
F
F
B
F
F
F
F
F
TR1H1253.EPS
MT - 39