Table of Contents
Advertisement
C
1
2
ONTENTS
To Calculate Correction Data
: 2.CALCULATION : 3.SHADING AND POLYGON
: 2.CALCULATION : 4.SHADING AND POLYGON FOR BAD CONDITION
: 2.CALCULATION : 5.POLYGON ONLY
Execute "3. SHADING AND POLYGON", "4. SHADING AND POLYGON FOR BAD
CONDITION" or "5. POLYGON ONLY".
When the recorded data is correct, the following message appears.
CALCULATION IS IN PROGRESS.
RESULT - OK (or RESULT - ERROR)
Meaning: Correction data calculation is now being performed.
If the recorded data is incorrect, the following message appears.
THE DATA IS RECORDED WITH INCORRECT SIZE.
Meaning: The data has been recorded with wrong size.
3. SHADING/POLYGON CORRECTION: To Apply Correction to Image
When "2. ON" is executed, the corrected data becomes effective in the routine mode.
Execute "3. SHADING/POLYGON CORRECTION: 2. ON".
Once the shading/polygon correction mode is set to ON, the following message
appears
THE NORMAL MODE WITH SHADING & POLYGON CORRECTION IS SET.
Meaning: Shading/polygon correction mode is set to ON.
If the process ends in error, the following message appears.
FILE I/O ERROR. (FILE=XXXXXXXXXX)
XXXXXXXXXX represents the file name.
4. SENSITIVITY DATA: To Enter S Value
It is used for set sensitivity correction (e.g., leveling the sensitivities of multiple readers).
(1) Select "4. SENSITIVITY DATA".
A message asking you to enter the current S value appears.
INPUT CURRENT S VALAUE.
1 - 999 :
(2) Enter the current S value within a range from 0 to 999.
A message asking you to enter a desired S value appears.
INPUT EXPECTED S VALUE.
1 - 999 :
(3) Enter the desired S value within a range from 0 to 999.
The calculation of set sensitivity correction value is initiated, with the following mes-
sage displayed.
INPUTTED S VALUE IS SET.
009-051-05
11.20.99 FM2638
3
4
5
6
CR-IR341 Service Manual
7
8
9
10
MU - 83
MU - 83
Advertisement
Chapters
Table of Contents
