FujiFilm CR-IR341 Service Manual page 605

C 1 2
ONTENTS
8.3 Checking and Replacing Grip Release HP Sensor (SD2)
Checks
CAUTION
Before removing the covers, be sure to turn OFF the high-voltage switch. If the machine is
powered ON with any of the covers removed, the photomultiplier will be damaged.
(1) Remove the following covers in order named.
Lower rear cover
"3. Removing and Reinstalling Covers"
(2) Power ON the machine.
(3) Place the machine in a state where the side-positioning mechanism HP sensor (SD1)
can be monitored.
"2.2 Checking Various Sensors"
(4) Rotate the cam of the grip mechanism to dislocate the actuator from the sensor.
A message indicating that the sensor is OPEN is displayed on the operation panel.
Side-positioning
conveyor
(5) Rotate the cam of the grip mechanism until the actuator causes the sensor to be
CLOSE.
A message indicative of the sensor CLOSE status is displayed on the operation
panel.
(6) Repeat steps (4) and (5) several times.
If no message is displayed, it is likely that the sensor is faulty. So, replace the sensor.
(7) Enter "0 (zero)".
The monitoring is quitted, and the screen returns to the "3. SENSOR" menu.
(8) Press the RESET button.
009-051-04
05.31.99 FM2460
3 4 5 6
T SW
SE
RE ote
Rem
ON al
Loc
F
OF
CR-IR341 Service Manual
7 8 9 10
Side-positioning
conveyor
SD2
MC - 114
FR1H1299.EPS
MC - 114