Drive Solenoid (Solc1) - FujiFilm CR-IR341 Service Manual

C 1 2
ONTENTS
6.4 Checking, Replacing, and Adjusting Convergence Path
Changeover Guide Drive Solenoid (SOLC1)
If anything abnormal is found during checks, adjust or replace SOLC1. When replaced,
adjust and check it again.
Checks
CAUTION
Before removing the covers, be sure to turn OFF the high-voltage switch. If the machine is
powered ON with any of the covers removed, the photomultiplier will be damaged.
(1) Power ON the machine.
(2) Touch the U-Utility button.
The screen switches to the U-Utility mode.
(3) Touch the upper left and upper right corners of the operation panel in sequence.
M-Utility is activated.
(4) Select "6. MECHANICAL UTILITY" and "2. ACTUATOR" in sequence.
(5) Select "2. DRIVE".
A list of actuator Nos. is displayed.
(6) Enter the number for SOLC1.
SOLC1 is driven.
If SOLC1 is not driven, it is likely that cable connection is faulty. Check the cable
connection, and select "2. DRIVE" again.
If it is not driven even after that, replace SOLC1.
Before-side-
positioning conveyor
(7) Repeatedly select "0. QUIT" to exit M-Utility.
A message prompting you to reset the machine is displayed.
(8) Press the RESET button.
009-051-04
05.31.99 FM2460
3 4 5 6
SOLC1
FR1H1114.EPS
CR-IR341 Service Manual
7 8 9 10
MC - 92
MC - 92