FujiFilm CR-IR341 Service Manual page 375

1 2
C
ONTENTS
03C6 Driving Shaft Grip Error / 03C8 Driving Shaft Grip Release Error
03CA Driving Shaft Grip Self-Diagnostics Error
Cause
03C6: MZ2 is driven before IP reading conveyance, but SZ2 does not turn OFF (IP not
ungripped).
03C8: MZ2 is driven before IP reading conveyance, but SZ2 does not turn ON (IP not
gripped).
03CA: MZ2 is driven during initialization, but SZ2 does not turn OFF.
Supplementary explanation
During IP reading conveyance or during initialization, MZ2 is driven to perform the grip/
grip release operation.
Either grip or grip release is detected as SZ2 turns ON/OFF.
When SZ2 is OFF, it is detected as grip; when SZ2 is ON, it is detected as grip re-
lease.
This error occurs when SZ2 does not transition from ON to OFF, or from OFF to ON,
during the above operation.
Sensor related
Error-related I/O locations
Error-related system block diagram
AC IN
DC OUT2
JPS-1
DC OUT3
009-051-04
05.31.99 FM2460
3 4 5 6
ON: Close, OFF: Open
MZ2
Driving shaft grip
SNS08A
CN
CN9
CN13
CN4
DRV03D
CN3
CN3
CN14
DRV08A
CN1
CR-IR341 Service Manual
SOLA4
SZ2 Driving-side grip release
HP sensor
CNZ2
CNZ3
CNZ8
MZ2
CNZ9
FR1H0054.EPS
MT - 106
FR1H0053.EPS
MT - 106