FujiFilm CR-IR341 Service Manual page 946

C 11 12
ONTENTS
16.1 Installing the Software (Application)
Installation Procedures
If the hard disk has been replaced, format it before installing the software.
"16.2 Formatting the Hard Disk"
Install the software (application) by sequentially inserting the "INSTALL" system disk and
data disks into the floppy disk drive in compliance with the message appearing on the
operation panel.
If any error occurs during the installation process, start all over again.
(1) Make sure that the machine is OFF.
If the power is ON, place the circuit breaker in the OFF position to turn OFF the ma-
chine.
(2) Insert the "INSTALL" system disk into the floppy disk drive.
CAUTION
Do not erroneously interchange the "INSTALL" system disk and "FORMAT" system
disk. If you turn ON the machine with the "FORMAT" disk set in position, the system
automatically starts formatting the hard disk so that you will lose all the data that have
been saved on the hard disk.
(3) Turn ON the machine.
The following messages appear on the operation panel.
Attaching to DMA device...done.
Attaching to <floppy> device...done.
Loading /fd0/VXWORKS.ST...43992 + 66184 + 29428
Starting at 0x1001000...
The following messages appear and the software installation process starts.
-> Install utility. Version A00.
Attaching to <floppy> device...done.
Attaching to <SCSI> device...done.
Upon completion of SCSI device initialization, the following message appears.
Insert data floppy disk.
009-051-05
11.20.99 FM2638
13 14 15 16
CR-IR341 Service Manual
17
MU - 155
MU - 155