FujiFilm CR-IR341 Service Manual page 871

C 1 2
ONTENTS
10.6 6. FORMAT: Setting Read Start Position and Read Width
The IP read start position (PIXEL) and the read width (FREQ) are temporarily set. Note,
however, that because the setup value in the hard disk is not overwritten, the data so
obtained is lost upon resetting.
Writing the settings to the hard disk is done in "8. DATA MANAGEMENT."
For more detail about the procedures for adjusting the read start position and read width,
see the Checks, Replacement and Adjustment Volume.
"9.1 Adjusting Read Start Position and Read Width" in Checks, Replacement and
Adjustment Volume
(-) (+)
PIXEL
1. DEFAULT: To Display Result after Setting Read Start Position and Read Width to
Their Default
The read start position (PIXEL) and read width (FREQ) are set to their default. The setup
values are not written to the hard disk.
1. Execute "1. PIXEL AND FREQ", "2. PIXEL ONLY", or "3. FREQ ONLY".
When it is executed normally, the following message appears.
FORMAT DATA IS SET TO THE DEFAULT VALUE.
Meaning: The format data is set to the default value.
009-051-05
11.20.99 FM2638
3 4 5 6
FREQ
(-) (+)
Enter the read width adjustment
value (a value in percentage,
to which increments/decrements
relative to the current read width
is converted).
Enter the read start position adjustment value
(a value, which is converted from the output image
to the actual dimensional value on IP) in pixels
(1 pixel = 0.1 mm).
CR-IR341 Service Manual
7 8 9 10
FR1H2000.EPS
MU - 80
MU - 80