FujiFilm CR-IR341 Service Manual page 770

C
11 12
ONTENTS
Setting Switch
Switch
General-purpose setup switch.
S1
The software reads the setting of this switch.
1) S2-1 and S2-2 (to be set up in the same manner)
Performs battery backup function ON/OFF setup.
2) S2-3
Turns ON or OFF the MTH08A NMI signal issuance
function. The OFF position must be selected because the
MTH08A does not currently have the NMI signal issuance
S2 function.
3) S2-4
Turns ON or OFF the boot ROM write function.
This function is not going to be used for the time being
because it is operative only when the flash EEPROM is
used as the boot ROM.
S3 Issues a manual reset.
S4 Issues a manual NMI.
Effects ID-Network line connection style
S5
(CROSS/STRAIGHT) changeover.
Effects IDT communication line signal level
S6
(RS-422/RS-232C) changeover.
Turns ON or OFF the power remote control function for
the IDT.
1) S7-1 and S7-2 (to be simultaneously set up)
Turns ON or OFF the IR-to-IDT power remote control
S7
function.
2) S7-3 and S7-4 (to be simultaneously set up)
Turns ON or OFF the IDT-to-IR power remote control
function.
How to Check Fuse
For no-fuse breaker (NFB)
The no-fuse breakers (NFB1-NFB4) are to be shorted (ON) at factory prior to shipment and
must be so at installation. However, since they may unexpectedly turn OFF due to vibration
during transit, press all the no-fuse breaker buttons two or three times to ensure that they
are depressed to ON.
ON position OFF position
For directly-mounted fuse
With board version G or later, the no-fuse breaker (NFB) is replaced with the fuse.
009-051-06 009-051-04
04.20.2001 FM3006 05.31.99 FM2460
13 14 15 16
Function
FR1H1353.EPS
"16.14 How to Check the Fuse on the Board"
CR-IR341 Service Manual
Factory Setup at
setup installation
Installation
All bits OFF
style dependent
OFF ON
OFF OFF
OFF OFF
— —
— —
STRAIGHT Installation
position style dependent
RS-422 Installation
position style dependent
ON ON
ON ON
TR1H1009.EPS
MC - 275
MC - 275