Table of Contents
Advertisement
C
1
2
ONTENTS
3.SHADING / POLYGON CORRECTION : It is set to ON when the corrected data is to be
4.SENSITIVITY DATA : Performs set sensitivity correction (e.g., leveling the sensitivities of
5.HV DATA : Should not be used in the market.
6.PMT DATA : Should not be used in the market.
8.DATA MANAGEMENT : Displays and writes to the hard disk the setup values for "6. FORMAT"
0.QUIT
1.SAVE SHADING AND POLYGON DATA : Writes the shading or polygon data to the hard disk.
2.SAVE SENSITIVITY DATA : Writes the sensitivity correction data to the hard disk.
3.SAVE FORMAT DATA : Writes the format data to the hard disk.
4.DISPLAY DATA : Displays set data for the format or sensitivity. NOTE 2
5.LOAD FROM FD : Reads the data in the floppy disk into the primary memory. The data read
6.SAVE TO FD : Writes to a floppy disk the shading, polygon, or sensitivity data in the hard disk.
9.DIAGNOSTIC : Executes all the diagnostic items.
10.VIRTUAL IMAGE : Causes the scanner hardware to generate a virtual image signal,
0.QUIT
1.LIGHT : Generates virtual light.
2.LOG AMP : Turns OFF the HV to generate an image signal of fixed output.
3.SCN08 INPUT : Causes the SCN08 board to generate an image signal.
4.ROUTINE : Cancel the virtual image signal generation mode to revert back to the initial state.
NOTE 1: Numerals in brackets denote a relevant chapter in this manual.
NOTE 2: The abbreviated alphabets displayed have the following meanings.
MP:
Number of invalid pixels
TMP:
Total number of invalid pixels
TML:
Total number of invalid lines
RCNT:
Reference frequency division value
NCNT:
Oscillation frequency setup value
HVCNT: Center-sensitivity HV value
009-051-05
11.20.99 FM2638
3
4
5
6
0.QUIT
1.ON
2.OFF
multiple readers).
Writing the correction value to the hard disk is done in "8. DATA
MANAGEMENT."
and "7. SHADING/SENSITIVITY."
is lost when the machine is reset.
0.QUIT
1.SHADING/POLYGON
2.SENSITIVITY
so that the resulting image is read to isolate the cause of trouble.
It should always be performed after the checks are completed in the virtual image
signal generation mode.
CR-IR341 Service Manual
7
8
9
10
enabled in routine mode.
HVDATA: Reading HV value
PMTK:
PMT sensitivity coefficient
SAIP:
IP sensitivity during sensitivity adjustment
Xe:
Erasure level dosage
Z:
Erasure level QL value
SMD:
SHD/polygon correction mode default value
MU - 18
[10.8]
[10.9]
[10.10]
FR1H1387.EPS
MU - 18
Advertisement
Chapters
Table of Contents
