FujiFilm CR-IR341 Service Manual page 862

1 2
C
ONTENTS
Setup Example 3: Printer Output Setup for Each Network Connection
NOTE
The HCP08A board (optional) and CPU90F board (optional) must be installed in the control
rack.
Perform network-specific printer output setup as indicated below.
SYSTEM (IRSET.CFG)
For "2. IPS" and "3. IPI", set appropriate IP addresses.
EQUIPMENT (EQUIP)
Set the transfer destination 5000 Series image reader host name as the PRINT attribute.
Note that only one 5000 Series image reader unit can be added.
| #
| PRINT
NETWORK HOST INTERFACE (DEVICE)
Set the host information about the 5000 Series image reader at the transfer destination.
| #
| fcr5000n-2:PRINT,0100,,
HOSTS ADDRESS (HOSTS)
Set the IP address of the 5000 Series image reader at the transfer destination.
| #
| 172.16.0.100
ROUTING (ROUTE)
If the transfer destination 5000 Series image reader is not within the same network, set the
IP address of the router that serves as the exit of the local network. If the destination image
reader is within the same network, this setting is not required.
NETMASKS (NETMASKS)
If the transfer destination QA-WS is not within the same network, set the subnet mask. If the
transfer destination QA-WS is within the same network, there is no need to make this entry
again.
Setup Example 4: CR-IR348CL Connection
"Appendix 9 Procedures for Connecting with CR Console (CR-IR348CL)" in "Installation
volume"
009-051-07
08.30.2001 FM3115
3 4 5 6
LOCAL fcr5000n-2
fcr5000n-2
CR-IR341 Service Manual
7 8 9 10
MU - 71
|
|
|
|
|
|
MU - 71