FujiFilm CR-IR341 Service Manual page 461

C 1 2
ONTENTS
4. Troubleshooting Procedures Based on
Improper Operation
4.1 Remedy When Cassette Cannot be Removed
Preliminary steps:
1. Power OFF the machine and remove the covers.
2. Turn OFF the high-voltage switch (S1) of the SCN08A board.
3. Check for any foreign matter (lead character marking chips, etc.) inside the machine, and, if any, remove it all.
Power OFF
Visually check inside the up-down IP
removal unit to ensure that the IP has
been returned to the cassette
completely.
Branch 2
Visually check to see that there is
nothing abnormal with SOLA1 — 4
of the up-down IP removal unit.
Cassette Removal (Standard Procedures)
Step 1: Remove the upper right-hand side cover of the machine.
Step 2: Push up the cassette hold bracket for the shelf to be released.
Its lock pin is released.
Step 3: With the cassette hold bracket pushed up, pull out the cassette.
Step 4: Reinstall the upper right-hand side cover of the machine.
Cassette Removal (Simple Procedures)
If the IP has been put back completely into the cassette and if it can
be verified that the solenoid operation is faulty, then insert the cassette
hold release tools into the four small holes located on the upper
right-hand side cover of the machine to release it without removing any
cover of the machine.
009-051-04
05.31.99 FM2460
3 4 5 6
Branch 1
N
Y
Power OFF
Power OFF
Power OFF
CR-IR341 Service Manual
Return the IP to the cassette
completely.
Or, remove the IP.
Perform the procedures
described in " Cassette
Removal" (see below on this
page).
Branch 2
Is the breaker fuse nn of the
DRV08A board normal?
Y
Are the connector
connections from SOLA1 to
DRV08A to JPS-1 board
normal?
Y
Replace the following parts
in order named.
DRV08A board
SOLA1 — 4
MT - 192
Branch 1
Restart the machine
and check its status.
N
Restore it.
Then, restart the machine
and check its status.
See Chapter Z to check
the wiring.
N
To check for harness
continuity, the machine
should be powered OFF
beforehand.
FR1H0137.EPS
MT - 192