FujiFilm CR-IR341 Service Manual page 701

C
11 12
ONTENTS
Reinstallation
NOTE
Make sure that the scanner unit has been pulled all the way out. If not, ME2 will interfere with
the machine frame when the after-reading conveyor is removed.
New type
(1) Reinstall the after-reading conveyor.
The four bumps of the right and left brackets of the after-reading conveyor should be
aligned against the block sections of the subscanning unit.
(2) Secure the right-hand side of the after-reading conveyor to the subscanning unit by
tightening the two screws in order from (2)-1 to (2)-2 as illustrated below.
(3) Make sure that the three bumps (two bumps on the right-hand side and one of the two
bumps on the left-hand side) are aligned against the block sections of the subscanning
unit.
SUPPLEMENTARY NOTE
Both of the two bumps on the right-hand side should be brought into contact with the block
section. At least one of the two bumps on the left-hand side may be in contact with the block
section.
If any of the bumps is detached from the block section of the subscanning unit, loosen
the two screws and repeat step (2) all over again.
Top view
(1), (3) Left-hand side
Bumps (At least
one of them
should be
contacted.)
Bracket
After-reading
conveyor
Subscanning unit
009-051-04
05.31.99 FM2460
13 14 15 16
Right-hand side
New after-reading
conveyor
Block section
CR-IR341 Service Manual
Side view
Block sections
of subscanning
unit
Bumps (Both of
them should be
contacted.)
Bracket
MC - 210
(1), (3)
New after-reading
conveyor
Bracket
Block section
(2)-1
BR M4x8
(2)-2
BR M4x8
FR1H1564.EPS
MC - 210