FujiFilm CR-IR341 Service Manual page 860

1 2
C
ONTENTS
Setup Example 2: QA-WS Connection
For the QA-WS connection, perform the following setup procedures.
NOTES
• The HCP08A board (optional) and CPU90F board (optional) must be installed in the control
rack.
• The Fuji Base-on-DICOM option software must be installed.
SYSTEM (IRSET.CFG)
• For "2. IPS" and "3. IPI", set appropriate IP addresses.
• For "45. UID_STI", set an appropriate examination instance user ID.
EQUIPMENT (EQUIP)
Set the transfer destination QA-WS host name ("qa-ws1") as the DISPLAY attribute.
To deliver the re-output from the QA-WS to the printer instead of directly delivering the
output from the image reader to the printer, set "LOCAL_R" as the PRINT attribute.
| #
| DISPLAY
| PRINT
NETWORK HOST INTERFACE (DEVICE)
Set the host information about the transfer destination QA-WS.
| #
| qa-ws1:DISPLAY,0200,,
HOSTS ADDRESS (HOSTS)
Set the IP address and host name of the local machine and transfer destination QA-WS.
| #
| 172.16.0.100
| 172.16.0.200
ROUTING (ROUTE)
If the transfer destination 5000 Series image reader is not within the same network, set the
IP address of the router that serves as the exit of the local network. If the destination image
reader is within the same network, this setting is not required.
009-051-05
11.20.99 FM2638
3 4 5 6
qa-ws1
LOCAL_R
fcr5000n-1
qa-ws1
CR-IR341 Service Manual
7 8 9 10
MU - 69
|
|
|
|
|
|
|
|
MU - 69